kascenevada.blogg.se - Behringer x32 rack tutorial

The iPad remote you just need to tap the setting you want to change. On the desk press the second rotary knob to switch between the two.

You will need to set both Left and Right channels, since you can assign different sources and input gain on the left and/or right channels of your recording.

Eg: Record Source Main L/R Post fader and you mute FOH is same as not recording any audio.

" Post Fader" is after all of the EQ, dynamic effects and the faders, so any changes you do while mixing for that channel will reflect on the final recording.

Use this if you want your recording to have the EQ and compressor etc effects on it, but don't want to be affected from your live mix when you bring up or down the fader during the mix.

" Pre Fader" will tap the signal before the fader AND before the mute switch. It also takes it after the EQ and dynamic effects.

Use this if you want to have an EQ corrected signal

" Post EQ" will tap the signal from just after the EQ, before the dynamic effects and the faders.

This will give you an almost "raw" signal

" Pre EQ" will tap before the EQ and everything else.

The " Tap" is from where the signal is recording from.

The default is normally from Main L/R and Post fader.

Signal source is where you select the signal from.

The "Category" table lets you quickly jump through the available Main busses, mixbuses, Matrix, direct outs and monitors.

The right hand side is your source selection and where the "Tap" is from.

You can adjust this up or down to get a decent recording level from the source

The left side shows you the input meter, and directly underneath it is the "Trim" or gain knobs.